C ute Easter card using Stampin' Up! products including a couple you can earn for FREE during Sale-A-Bration 2024.
Project Recipe
Cut cardstock and designer paper pieces to the following sizes using a Paper Trimmer:
- card from Petal Pink Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" from Pecan Pie Cardstock
- 3-7/8" x 5-1/8" from Very Vanilla Cardstock
- 2" x 5-1/8" of light brown chicken wire on darker brown background design from Flight & Airy 12" x 12" Designer Series Paper
- 1-1/2" x 3" from Pecan Pie Cardstock
Mount the "happy Easter" sentiment from the Excellent Eggs Set on Block C. Ink it up with the Pecan Pie Ink Pad. Stamp it in the upper left corner of the horizontal Very Vanilla rectangle.
Adhere the strip of Flight & Airy Designer Paper to the bottom of the stamped, horizontal Very Vanilla rectangle.
Adhere the stamped Very Vanilla rectangle with designer paper attached to the center of the large Pecan Pie rectangle.
Cut a 4-3/4" piece of the Petal Pink ribbon from the Ribbon Duo Combo Pack. Lay the ribbon across the matted cardstock/designer paper rectangle so it covers the seam between the vanilla cardstock and designer paper. Fold the ends of the ribbon over and secure the ribbon in place on the back with strips of Tear & Tape Adhesive.
Remove the protective backings from the Tear & Tape pieces and add Stampin' Seal to the back of the Pecan Pie rectangle. Adhere the rectangle to the front of the Petal Pink card.
Mount the small bunny image from the Excellent Eggs Set on Block B. Ink it up with the Early Espresso Ink Pad. Stamp it three times on the Pecan Pie strip. Remember to re-ink the stamp each time. Leave room between each image to cut them out with the die in the next step.
Pick out the matching, open bunny die from the Excellent Eggs Dies. Put it on top of one of the stamped bunny images on a platform on your Stampin' Cut & Emboss Machine so the image is centered in the die. Run through the machine. Repeat with the other two bunny images.
Use Mini Stampin' Dimensionals to adhere the three bunny cut outs in a row on the card front so the bottoms are just above the top of the ribbon on the right side.
Cut a 3" piece of the Petal Pink ribbon from the Ribbon Duo Combo Pack.
Slide one end of the ribbon under the ribbon already on the card front on the left side. Tie in place with a half knot. Trim the ends.
Use the mini spatula on the Take Your Pick to carefully peel up 1 large and 2 small Calypso Coral gems from the sheet of Opaque Faceted Gems making sure that you get the adhesive backings as well. Adhere them to the card front as shown in a straight, horizontal line in the bottom right corner so the large gem is in the center of the line.